5) Self Revert If during programming no button is pressed for between one and two minutes the Digistat will revert automatically to its normal operating mode. This resets the Digistat to the factory preset times and temperatures shown in the table (overleaf). 4) Reset If at any time during the programming you get confused and would like to start the procedure from the beginning press the SELECT and – buttons at the same time and hold for two seconds. 3) Programme Sequence The Digistat will not allow you to program the switched periods out of sequence but will hold the times together as stated above. For example, if all four switching times were set together the Digistat would control continuously at the fourth (night) temperature setting.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |